Section I Model 201C
Table 1-1. Specifications
Frequency Range: 20 Hz to 20 kHz in three ranges. Hum Voltage: Less than 0.03% of rated or attenuated
output. (Amplitude control at maximum.)
Ranges
x1 20 Hz to 200 Hz Power: 115/230 volts f lo%, 48/440 Hz 85 W
x10 200 Hz to 2 kHz nominal. 120 W maximum.
XlOO 2 kHz to 20 kHz
Calibration Accuracy: *I%. Calibration controls Accessories Available:
provided for standardizing bands.
HP llOOOA Cable Assembly, 4 feet of RC-SS/U
Frequency Stability: *2% under normal temperature SO-ohm coaxial cable terminated at each end with a
conditions and including initial warmup, aging of dud banana plug.
components etc.
HP llOOlA Cable Assembly, 45 inches of RC-SS/U
Dial: 6-inch diameter, calibrated over 3OOo of arc. SO-ohm coaxial cable terminated at one end with a
Total scale length SO inches.
dual banana plug and with a UGSS/U Type BNC male
connector at the other.
Frequency Response: +1 dB over entire frequency range
(Reference 1 kHz.)
Dimensions:
Output: 3 watts maximum or 42.5 volts into 600-ohm
load. One terminal at ground potential. SO volts Cabinet Mount: 7-1/2 inches wide, 11-1/2 inches high,
maximum no-load voltage. 12-1/2inches deep.(l91 X292X318mm).
Distortion: Less than 1/2%, 50 Hz to 20 kHz at 1 watt
Rack Mount: 19 inches wide, 6-31/32 inches high,
output. Less than I%, 20 Hz to 20 kHz at 3 watts 10-5/16 inches deep (482,6 X 177,O X 261,9 mm).
output.
Weight:
Attenuator: 0 to 4OdB in 10 dB steps-concentric e
amplitude control varies output continuously zero
to maximum at any attenuator setting. Cabinet Mount: Net, 16 Ibs. (7,2 kg);Shipping, 19 Ibs.
(86 kg).
Output Impedance:
600 ohms ?lo%, 20 dB, 30 dB and 40 dB settings Rack Mount:
Less than 600 ohms, 0 dB and 10 dB settings. Net, 20 Ibs. (9 kg);Shipping, 30 Ibs. (13.5 kg) |