Model 3325A General Information
Tabla 1.2. Suoalemental Information Uhnt?dl.
X Drive Output Eweep up only): Frequency Switching and Settling Time: *
Amplitude: 0 to + 10 V linear ramp proportional to
sweep frequency < 10 ms fo within 1 Hz of final value for 100 kHz span
Connector: Rear panel BNC ~25 ms to within 1 Hz of final value for 1 MHz span
Z Blank Output: < 70 ms to within 1 Hz of final value for 20 MHz span
Levels ,TTL compatible voltage levels~:
Linear Sweep: Phase Switching and Settling Time:?
Single: Low et start of weep. High at stop. Re- < 15 ms to within 90° of phase lock for 20 MHz fre-
mains High until start of next sweep. q?e?CyCha?ge
Continuous: Low during weep up. High during Amplitude Switching Time:?
sLwep down. ~30 ms to within amplitude specifications
?Times shown are in addition to programming time
Log Sweep:
Single: Low at start of sweep. High at stop. Re- OEIERIL
mains High until start of next sweep.
Operating Environment:
Continuous: Low during sweep. Goes High
momentarily at stop frequency.
Temperature: O? to 55OC
Relative Humidity: ~95%. On to 40°C
10 MHz Oven Reference Output. Option 001, for phase
Altitude: 5 15,000 ft.
locking the 3325A to the optional high stability frequency
reference:
storage Tampetature: - 500 to + 75oc
Storage Altitude: r50.000 ft.
Amplitude: 0 d9m. 50 ohms
Power Requirements:
Connector: Rear panel BNC. Must be connected to
the rear panel EXT REF IN connector.
,00,,20,220,240?+5%.- 1036.48 to 66 Hz
SO VA, 100 VA with all options. 10 VA standby
Dimensions in millimeters and linches):
REMOTE CONTROL
132.6 15%) high x 425.5 (16%I wide x 497.9
,I 9-5/S) deep
Hewlet+Packard Interface Bus (HP-19, Control: (HP-19 is
Hewlett-Packard Company?s implementation of IEEE Stan- Weight in kilograms and Ilbs):
dard 488-l 978). Time shown is in addition to programming
time. Net weight: 9(201
Shipping Weight: 14.5 I321
The following accessory options are also available for 1.19. ACCESSORIES AVAILABLE.
the Model 3325A:
. . ^
l-20. The following accessories are available for use
option 907 Front Handle Assembly with the Model 3325A:
Option 908 Rack Mount Flange Kit
Option 909 Rack Mount Flange Kit/Front Number Description
Handle Assembly
Option 910 Additional Operating and Service 11048C 50 ohm Feedthru Termination
Manual
11356A Ground Isolator
03325-80001 Oven Board Assy. (Converts 3325A to
Option 001)
03325-80002 High Voltage Option (Converts 3325A
1.17. ACCESSORIES SUPPLIED. to Option 002)
I-18. A special connector is supplied with the High 5061-0077 Rack Mount Flange Kit (Option 908)
Stability Frequency Reference Option 001 for connect-
5061-0083 Rack Mount Flange/Front Handle Kit
ing the rear panel Reference Output to the Reference In-
(Option 909)
put. This connector is Part No. 1250-1499.
5061-0089 Front Handle Kit (Option 907) |